-
Reinforcement, topline, backseam, and double-sided tapes -
Water-based leather dyes, 10 ounce bottles -
Usage instructions: Aquilim 315, contact cement Directions: Make sure that both surfaces are clean and roughed-up so adhesive can penetrate. Apply adhesive to both surfaces by brushing or spraying and allow to dry completely. Adhesive will turn clear when it’s dry and ready for adhesion; this will take 20-30 minutes depending on humidity. Once adhesive is dry and clear, stick the items to be bonded together and hammer or press. Aquilim GL, rubber cement Directions: The Aquilim GL only needs to be applied to one of the surfaces that will be stuck together. Using a brush or a spray gun, apply adhesive to the back or the roughed-up surface of one piece of leather. While the adhesive is still wet, immediately bond the two surfaces; press or hammer together. Aquilim SG, temporary bond Please note: Due to bottling and consistency issues, Aquilim SG has been removed from the website until further notice. -
5/16" leather side welt and 3/8" leather beading -
Beading Cord #346 Thread, Natural, 8 oz spool -
2 ounce cake of beeswax -
Biltrite rubber cowboy boot heel caps -
Boot boxes, 19x15x6", Kraft brown interior/white exterior, tuck and fold closure for secure shipping Sold in bundles of 10 boxes, SHIPPING INCLUDED -
Braided thread for sole stitching; 500 meter spools Spools weigh 10 ounces All colors are 1mm unless it's noted that it's 1.2mm 1.2mm is roughly the size of 6 cord, and 1mm is slightly smaller than 6 cord -
Klingspor cloth-backed sandpaper: 60, 100, 220, and 600 grits Sold in packages of four sheets, or one package of two each of all four grits Naumkeg papers, 120 grit -
Contour gauge -
Crimp boards and screws sold in pairs Please note: You can crimp any size vamp on any of these boards, but the leather will match the board's length and crimp screw opening better if you're using the correct size. Link to a Crimp Break
