-
3/8" Chisel -
Reinforcement, topline, backseam, and double-sided tapes -
Usage instructions: Aquilim 315, contact cement Directions: Make sure that both surfaces are clean and roughed-up so adhesive can penetrate. Apply adhesive to both surfaces by brushing or spraying and allow to dry completely. Adhesive will turn clear when it’s dry and ready for adhesion; this will take 20-30 minutes depending on humidity. Once adhesive is dry and clear, stick the items to be bonded together and hammer or press. Aquilim GL, rubber cement Directions: The Aquilim GL only needs to be applied to one of the surfaces that will be stuck together. Using a brush or a spray gun, apply adhesive to the back or the roughed-up surface of one piece of leather. While the adhesive is still wet, immediately bond the two surfaces; press or hammer together. Aquilim SG, temporary bond Please note: Due to bottling and consistency issues, Aquilim SG has been removed from the website until further notice. -
Inseaming, sewing, and pegging awl hafts -
Beading Cord #346 Thread, Natural, 8 oz spool -
2 ounce cake of beeswax -
Biltrite rubber cowboy boot heel caps -
Bissonnette edger -
Each shoemaking kit contains: One pair 7/8 iron Baker Leather insole and outsole OR one pair 9/10 Baker Leather insole and outsole, one Baker Leather welt strip, one pair Baker Leather half moon toe puffs, one Baker Leather lifting piece large enough for three pairs of heel lifts, and one mens pre-formed leather counter Coming soon: Boot making kit! -
Boot boxes, 19x15x6", Kraft brown interior/white exterior, tuck and fold closure for secure shipping Sold in bundles of 10 boxes, SHIPPING INCLUDED -
Shoe hammer, plain French hammer, square point knife, wide lasting pliers, heel pry, tack puller, pegging awl haft and two 40mm pegging awls, inseaming awl haft and one 3 3/8" inseaming awl, and right-handed lip knife If you need a left-handed lip knife, please specify that in the NOTE section -
Braided thread for sole stitching; 500 meter spools Spools weigh 10 ounces All colors are 1mm unless it's noted that it's 1.2mm 1.2mm is roughly the size of 6 cord, and 1mm is slightly smaller than 6 cord
